Dear Experts
We have a HMC machine wherein we have problem of bore getting oversized.
We have checked following:
Tool clamping force inside Spindle
Run out on test mandrel for HSK63 checked both at nose as well as at 250mm
Taper along test mandrel checked
Component clamping on fixture found alright
Overhang of boring bar
Tool replaced with new one
Cutting parameters checked and found ok vis a vis original program of the machine
Request to suggest us check points to overcome issues like Bore oversize, Ra,Rz (Surface finish) more than permissible limits, Chattering in Bore and taper along z axis
Regards
It sounds like you've investigated all possible causes. Perhaps you should contact experts for assistance and find the cause of the problem. geometry dash